KIA Niro: Warning and indicator lights
Ready indicator READY
This indicator appears:
When the vehicle is ready to be driven.
- ON: Normal driving is possible.
- OFF: Normal driving is not possible, or a problem has occurred.
- Blinking: Emergency driving.
When the ready indicator goes OFF or blinks, there is a problem with the system.
If this occurs, we recommend that you have your vehicle inspected by an authorized Kia dealer/service partner.
Service warning light
This warning light appears:
- When you set the ENGINE START/ STOP button to the ON position.
- The service warning light appears for approximately 3 seconds and then turns off when all checks have been performed.
- When there is a problem with the hybrid vehicle control system or hardware.
When the warning light appears while driving, or does not go OFF after starting the vehicle, we recommend that you have the vehicle inspected by an authorized Kia dealer/service partner.
EV mode indicator
This indicator appears:
When the vehicle is driven by the electric motor.
- "EV" indicator ON: Vehicle is driven using the electric motor or the gasoline engine is stopped.
- "EV" indicator OFF: Vehicle is driven using the gasoline engine.
Regenerative brake warning light (red color) (yellow color)
This warning light appears:
When the regenerative brake does not operate and the brake does not perform well. This causes the brake warning light (red) and regenerative brake warning light (yellow) to appear simultaneously.
If this occurs, drive safely and have your vehicle inspected by an authorized Kia dealer/service partner. The operation of the brake pedal may be more difficult than normal and the braking distance may increase.
Charging cable connection indicator (Plug-in hybrid vehicle)
This indicator appears in red when the charging cable is connected.
READ NEXT:
LCD display messages
Ready to drive A: Ready to start driving This message is displayed when the vehicle is ready to be driven. Check regenerative brakes A: Check regenerative brakes This message is displayed when the brake performance is low or the regeneAUTO (Automatic) mode (Plug-in hybrid vehicle)
A: Automatic mode The drive mode will be automatically selected from either Electric (CD) mode or Hybrid (CS) mode by the system according to the driving condition. CS (Charge Sustaining, Hybrid) mode (Plug-in hybrid vehicle) A: HybriEnergy flow
The hybrid system informs the drivers its energy flow in various operating modes. While driving, the current energy flow is specified in 11 modes. Vehicle stop A: Idle Mode The vehicle is stopped. (No energy flow) EV propulsion A:SEE MORE:
Duct Sensor Repair procedures
Inspection Check that the voltage between No. 1 and 2 duct sensors change. Sensor (+ 5V) Sensor ground Specification Replacement Duct sensor - Floor Disconnect the negative (-) battery terminal. Remove the crash pad lowSetting smart regeneration system (Kia Niro EV)
Smart regeneration system The Smart Regeneration System controls the regenerative braking automatically according to the road gradient and driving condition of the vehicle in front. The system minimizes the unnecessary operation of the brakeCategories
- Home
- KIA Niro EV, Hybrid - Second generation - (SG2) (2021-2024) - Owner's manual
- Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual
- Contact Us