KIA Niro: Gel pad
Replacement
- Remove the damaged silicone gel pad completely on the lens plate of rain sensor.
Warning
- The silicone gel must be fully detached from the rain sensor by rubbing it off with the fingers without any tool.
- The surface of the lens plate must neither be damaged nor polluted by this activity.
Warning
It is recommended to remove any residues from the lens plate surface with pressurized air.
- Remove the two protection foils (A) from the gel pad.
- Attach the silicone gel pad (A) on the lens plate of rain sensor by hand.
Warning
In case that silicone gel pad of rain sensor is polluted by foreign
substances, remove the foreign
substances by using the sticker roller.
READ NEXT:
Heating, Ventilation And Air Conditioning / Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if
the malfunction is due to
the refrigerant charge, air flow or compressor.
Use the table below to find the cause of the problem. The numbers in
SEE MORE:
Hood Assembly Repair procedures
Replacement
Warning
Be careful not to damage the hood and body.
Warning
Work in a group of two when removing and installing the hood.
Use a clip remover to remove clips.
Remove the hood assembly (A) after loosening the hood hinge mount
Energy flow
The hybrid system informs the drivers its
energy flow in various operating modes.
While driving, the current energy flow is
specified in 11 modes.
Vehicle stop
A: Idle Mode
The vehicle is stopped.
(No energy flow)
EV propulsion
A:
Categories
- Home
- KIA Niro EV, Hybrid - Second generation - (SG2) (2021-2024) - Owner's manual
- Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual
- Contact Us
