KIA Niro: Decreasing set speed
- Push the (-) switch down and release it immediately. The set speed will decrease by 1 km/h (1 mph) each time the switch is operated in this manner.
- Push the (-) switch down and hold it.
The set speed will decrease by 10 km/ h (5 mph) each time the switch is operated in this manner.
You can decrease the set speed to 30 km/h (20 mph).
Temporarily canceling Smart Cruise Control
Press the ( ) switch or depress
the
brake pedal to temporarily cancel Smart
Cruise Control.
Resuming Smart Cruise Control
To resume Smart Cruise Control after
the function was canceled, operate the
(+), (-) or ( ) switch.
If you push the (+) switch up or (-) switch down, the set speed will be set to the current speed on the cluster.
If you press the () switch, vehicle
speed will resume to the preset speed.
WARNING
Check the driving condition before using
the ( ) switch. Driving speed may
sharply increase or decrease when you
press the (
) switch.
Turning off Smart Cruise Control
Press the Driving Assist button to turn Smart Cruise Control off.
NOTICE
If your vehicle is equipped with Manual Speed Limit Assist, press and hold the Driving Assist button to turn off Smart Cruise Control. However Manual Speed Limit Assist will turn on.
WARNING
Do not use the switches and buttons at the same time. Smart Cruise Control may not operate properly.
READ NEXT:
Displaying operating status
You can see the status of the Smart
Cruise Control operation in the Driving
Assist view on the cluster. Refer to "LCD
display modes"
Smart Cruise Control will be displayed as
below depending on the status of the
function.
Operating
Temporarily canceling Smart Cruise Control
A: SCC (Smart Cruise Control) cancelled
Smart Cruise Control will be temporarily
canceled automatically when:
Your driving speed is above 200 km/h
(120 mph)
The vehicle is stopped for a certain
period of time
The accelerator pedal i
Collision warning
A: Collision warning!
While Smart Cruise Control is operating,
when the collision risk with the vehicle
ahead is high, the warning message will
appear on the cluster, and an audible
warning will sound to warn the driver.
Always have your
SEE MORE:
Power Seat Motor
Power Seat Motor Components and components location
Lumbar support motor (Horizontal)
Slide motor
Reclining motor
Rear height motor
Front tilt motor
Reclining limit switch
Seat cushion switch
Seat back switch
Lumbar support sw
Rear Cross Member Repair procedures
Removal
Disconnect the battery negative cable.
Remove the wheel and tire.
Tightening torque:
107.9 - 127.5 N*m (11.0 - 13.0 kgf*m, 79.6 - 94.0 lb*ft)
Warning
Be careful not to damage the wheel nuts when removing the wheel and
tire.
Categories
- Home
- KIA Niro EV, Hybrid - Second generation - (SG2) (2021-2024) - Owner's manual
- Kia Niro - First generation - (DE) (2017-2022) - Service and Repair Manual
- Contact Us